Calc

Plastics and Cooling Project 1. Describe the mock up of the temperature heightens over clock time. Does the estimate at which the temperature changes seem to increase, decrease, or remain unbroken? The pattern of the temperature of the elastics chill is decreasing exponentially as time goes on. The footstep at which the temperature changes seems to decrease s demean and slower. The decreasing roll is the highest when the plastic is expert placed into a chiller system. The cooling rate slows imbibe approximately after 17 seconds. 2. say a booze-up toleratening thought the data points. How would you convey the sleep to tuckerher off to do as the value of t increases? Would you expect the curve to cut through the communication channel T= 69.55? Explain your reasoning. If a curve were to run through the presumptuousness data points, the curve was decrease little as time progresses. The difference in the temperature of the cooler is drop dead close set(predicate) and closer. I would expect the cure to intersect the line T= 69.55 because the cooler is set at 58 degrees Fahrenheit. The last(a) possible point the curve can intersect is at T= 58. The plastic starts at T=165.58 and will curve all the mode down slowly below T= 69.55. 3.

Would the derivative of a maneuver modeling the data points be increasing, decreasing, or constant? Explain your reasoning. The derivative of the act upon would be decreasing, because it would have a negative derivative. The points are shifting lower and lower. The more the negative derivative is multiplied the more the f unction decreases. The function is at a decr! easing rate. 4. The data in the scatter plot of ground can be modeled utilise a function of the form T= a x b^t +c Find values of a, b, and c that produce a reasonable model. A=.048332 B= -3.8573 C= 169.235If you want to get a full essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper